Revision [34329]
This is an old revision of LiveUSB made by coolpup on 2025-12-09 05:07:29.
Running Computer Operating System Directly From External Data Storage Device
Run an operating system directly from an external data storage device:
- bypassing the existing, internal operating system on one's computer
- without altering the configuration of the existing, internal operating system on one's computer (unless one deliberately chooses to do so in order to fix a broken system configuration)
External data storage devices:
- S.D. flash memory card
- U.S.B. flash memory drive
- solid-state drive (S.S.D.)
- hard disk drive (H.D.D.)
- optical disc drive (O.D.D.) (see LiveDVD)
How to run/start an operating system directly from an external storage device
- Acquisition
- acquire the disk image file (with file extension .img or .iso) of the desired operating system, such as a recent Puppy Linux release (read Appendix 2);
- Verification
- next, verify the authenticity of the downloaded file VerificationCommands;
- Flashing/Writing
- next, flash/write the disk image file (with file extension .img or .iso) to an external storage device;
- Connection
- next, ensure the external device is connected to the computer, usually via a USB port;
- Boot Sequence
- next, ensure that the U.E.F.I./B.I.O.S. firmware (low-level software that starts just prior to the operating system doing so) settings is configured to follow the desired BootSequence;
- Power-Off
- next, ensure that the computer is put in a complete power-off state;
- Power-On
- next, power-on the computer.
How to flash/write a disk image file to external storage device (except optical disc drive)
- From within GNU+Linux (select one of the following software tools)
- dd command
- ensure the target device (external storage device) is disconnected, or remove all removable USB devices, from the computer
- next, list all known disk devices connected to the computer, via the command-line interface:
lsblk -al
- next, connect the target device to the computer via an USB port
- next, determine the correct device name, which has the format sdX, of the target device by invoking the lsblk command again, and comparing both outputs:
lsblk -al
- then, flash (write) the disk image file (with file extension .img or .iso) to external device, via the command-line interface
- WARNING the dd command will overwrite all existing data on the target device sdX, where X refers to the device letter for your target device - USE ENTIRELY AT YOUR OWN RISK:
time sudo dd bs=4M conv=notrunc,fdatasync oflag=direct status=progress if=<DISK_IMAGE_FILE> of=/dev/sdX
- where <DISK_IMAGE_FILE> is replaced with the actual disk image file name, with file extension .img or .iso
- From within Android:
- ensure an external device is connected to the smartphone/tablet, via the USB port
- then, use the following free software program:
- From within Microsoft Windows:
- ensure the external device is connected to the computer, usually via a USB port
- then, use one of the following tools:
- Rufus (the latest version of Rufus requires Windows 8 or later; last supported version for Windows 7 is version 3.22)
How to flash/write a disk image file to external storage device (optical disc drive only)
Appendix
HomePagePlus | RecentChanges | Forum
