Puppy Boot Parameters: PuppyLinux

Revision [20184]

This is an old revision of BootParameters made by darkcity on 2012-01-04 11:00:03.

HomePage > ComponentHowTo Components and HowTos > BootIndex Booting

Boot Parameters Introduction

These are parameters or arguments that control how Puppy Linux boots up. Where they are specified depends on if and how Puppy is installed.

If booting from CD/DVD then the parameters are set at the prompt shown before Puppy boots. Usually, if no key is pressed after 5 seconds then Puppy will load with default settings. Example: puppy pkeys=us

Booting from a USB installation

The parameters are set in the 'syslinux.cfg' file, example:
Example: default vmlinuz initrd=initrd.gz pmedia=usbflash

Frugal Installation

With frugal installation the parameters are set by one of the BootLoaders Boot Loader's files. GRUBand GRUBforDOS use the 'menu.1st' file.
title Puppy Linux 525 rootnotify (hd0,0) kernel (hd0,0)/vmlinuz pmedia=atahd psubdir=puppy525 initrd (hd0,0)/initrd.gz

Full Installation

"...Pfix=nox doesn't work in full install because the code that interprets this only exists in initrd.gz, and full-install doesn't use initrd.gz. (In fact, all other puppy boot parameters will not work in full install)"
see forum

Other Boot Loaders

Read the documentation included with other boot loaders for where to include these parameters. The parameters are case-sensitive, so ensure it's exactly as shown. Additionally, vmlinuz is the filename of the kernel image that one would need to specify when using a boot loader. See the isolinux.cfg & boot.msg files in the CD image (.ISO) or on the CD/DVD for a little more on each version's normal boot options.